Wet H2S Gas Monitor: ATI Model Q45S
The wet H2S gas monitor utilised specially developed sensor technology allowing the continuous monitoring of hydrogen sulphide in both inlet and discharge air, where condensing humidity conditions are normal.
How it works:
The odour monitoring system uses the Q45 electronics package in conjunction with a special “Wet H2S” sensor. Measurements may be made either at the inlet to scrubber systems where concentrations can run as high as 200 PPM, or at the outlet where concentrations are ideally down below 0.5 PPM. Special sensor configurations are available for either duct insertion or flowcell use.
Features and Benefits:
Special Wet H2S Sensors: The system utilises a special sensor designed to operate in condensing gas streams without the water vapour blinding typical of standard sulfide sensors
Technical Specifications:
Gas Type:Hydrogen Sulfide
Sensor Type:Special wet gas sensor design
Display:0-2.000 PPM, 0-20.00 PPM, 0-200.0 PPM (programmable)
Response Time:90% in 120 seconds
Accuracy:Generally ±10% of value, but limited by available calibration gas
Sensitivity:0.1 PPM minimum
Zero Stability:± 0.04 PPM